190-02692-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
169
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Figure 5-25 WAYPOINT INFORMATION Window – Duplicate Identifier
Duplicate Message
Identifier with
Duplicates
Duplicate Waypoints
AIRPORTS
NOTE: North Up orientation on the WPT – AIRPORT INFORMATION Page cannot be changed; the pilot
needs to be aware of proper orientation if the Navigation Map orientation is different from the WPT –
AIRPORT INFORMATION Page Map.
The WPT – AIRPORT INFORMATION Page allows the pilot to view airport information, load frequencies
(COM, NAV, and lighting), review runways, and review instrument procedures that may be involved in the
flight plan. See the Audio Panel and CNS Section for more information on loading frequencies (auto-tuning).
After engine startup, the WPT – AIRPORT INFORMATION Page defaults to the airport where the aircraft is
located. After a flight plan has been loaded, it defaults to the destination airport. On a flight plan with multiple
airports, it defaults to the airport which is the current active waypoint.
In addition to displaying a map of the currently selected airport and surrounding area, the WPT –
AIRPORT INFORMATION Page displays airport information in three boxes labeled AIRPORT, RUNWAYS,
and FREQUENCIES. For airports with multiple runways, information for each runway is available. This
information is viewed on the by pressing the INFO Softkey until ‘INFO-1’ is displayed.
To Next Page
Loading...
Need help?
General
