GE MEDICAL SYSTEMS
DIRECTION 2317229, REVISION 3 LOGIQ™ 180 BASIC SERVICE MANUAL
1 - 14 Section 1-3 - Safety Considerations
1-3-6 Dangerous Procedure Warnings
Warnings, such as the example below, precede potentially dangerous procedures through our this
manual. Instructions contained in the warnings must be followed.
1-3-7 Lockout/Tagout Requirements (For USA/Europe Only)
Follow OSHA Lockout/Tagout requirements by ensuring you are in total control of the plug.
1-3-8 Classification
Type of protection against electric shock: Class I EQUIPMENT *1
Degree of protection against electric shock: Type BF EQUIPMENT**2
1.) *Class I EQUIPMENT
EQUIPMENT in which protection against electric shock does not rely on BASIC INSULATION
only, but which includes an additional safety precaution in that means are provided for the
connection of the EQUIPMENT to the protective earth conductor in the fixed wiring of the
installation in such a way that ACCESSIBLE METAL PARTS cannot become LIVE in the
event of a failure of the BASIC INSULATION.
2.) **Type BF EQUIPMENT*
Type B EQUIPMENT with a F-TYPE isolated applied part providing a degree of protection
against electric shock to such a degree that the allowable PATIENT LEAKAGE CURRENT
under SINGLE FAULT CONDITIONS is not exceeded when 1.1 times the highest rated
MAINS VOLTAGE is applied between the APPLIED PART and earth.
DANGER
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.
WARNINGWARNING
Explosion warning: do not operate the equipment in an explosive atmosphere.
Operation of any electrical equipment in such an environment constitutes a definite
safety hazard.
WARNINGWARNING
Do not substitute parts or modify equipment: because of the danger of interdicting
additional hazards, do not install substitute parts or perform any unauthorized
modification of the equipment.
To Next Page
Loading...
Need help?
General
