HIKVISION DS-K1A802A Series User Manual

Note
●
This funcon should be supported by the device.
●
You can log into the device to get the cercate le by web browser.
7.
Check Synchronize Time to synchronize the device me with the PC running the client aer
adding the device to the client.
8.
Oponal: Check Import to Group to create a group by the device name.
9.
Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the
sengs and connue to add other device.
10.
Perform the following
operaons aer adding the devices.
Remote
Conguraon
Click on Operaon column to set remote conguraon of the
corresponding device.
Note
●
For some models of devices, you can open its web window. To open
the original remote conguraon window, press Ctrl and click .
●
For detail operaon steps for the remote conguraon, see the user
manual of the device.
Device Status Click on Operaon column to view device status.
6.1.4 Add Device by EHome Account
For areas where devices using dynamic IP addresses instead of stac ones, you can add access
control device connected via EHome protocol by specifying the EHome account.
Before You Start
Set the network center parameter
rst. For details, refer to Set Network Parameters .
Steps
Note
For the devices added by EHome don't support uploading events with captured pictures to the
client.
1.
Enter Device Management module.
2.
Oponal: Click on the right of Device Management and select Device.
The added devices are displayed in the list.
3.
Click Add to open the Add window.
4.
Select EHome as the adding mode.
5.
Enter the required
informaon.
Device Account
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
50

HIKVISION DS-K1A802A Series Specifications

General

Brand	HIKVISION
Model	DS-K1A802A Series
Category	Touch terminals
Language	English