To Next Page

To Previous Page

2. Select the person you want to report card loss for and click Edit to open the Edit Person

window.

3. In the

Credenal → Card panel, click on the added card to set this card as lost card.

Aer reporng card loss, the access authorizaon of this card will be invalid and inacve. Other

person who gets this card cannot access the doors by swiping this lost card.

Oponal: If the lost card is found, you can click to cancel the loss.

Aer cancelling card loss, the access authorizaon of the person will be valid and acve.

5. If the lost card is added in one access group and the access group is applied to the device

already,

aer reporng card loss or cancelling card loss, a window will pop up to nofy you to

apply the changes to the device. Aer applying to device, these changes can take eect on the

device.

8.4.20 Set Card Issuing Parameters

The client provides two modes for reading a card's number: via card enrollment staon or via the

card reader of the access control device. If a card enrollment staon is available, connect it to the

PC running the client by USB interface or COM, and place the card on the card enrollment to read

the card number. If not, you can also swipe the card on the card reader of the added access control

device to get the card number. As a result, before issuing a card to one person, you need to set the

card issuing parameters including the issuing mode and related parameters.

When adding a card to one person, click

Sengs to open the Card Issuing Sengs window.

Local Mode: Issue Card by Card Enrollment Staon

Connect a card enrollment staon to the PC running the client. You can place the card on the card

enrollment

staon to get the card number.

Card Enrollment Staon

Select the model of the connected card enrollment staon

Note

Currently, the supported card enrollment staon models include DS-K1F100-D8, DS-K1F100-M,

DS-K1F100-D8E, and DS-K1F180-D8E.

Card Type

This eld is only available when the model is DS-K1F100-D8E or DS-K1F180-D8E.

Select the card type as EM card or IC card according to the actual card type.

Serial Port

It is only available when the model is DS-K1F100-M.

Select the COM the card enrollment

staon connects to.

Buzzing

Enable or disable the buzzing when the card number is read successfully.

DS-K1T341B Series Face Recognion Terminal User Manual

HIKVISION DS-K1T341B Series User Manual

Questions and Answers: