HIKVISION iDS-9600NXI-I16/4F Series User Manual

Figure 1-8 TCP/IP Sengs
2. Select Working Mode as Net-Fault Tolerance or Mul-Address Mode.
Net-Fault Tolerance
The two NIC cards use the same IP address, and you can select the main NIC to LAN1 or LAN2.
In this way, in case of one NIC card failure, the device will
automacally enable another
standby NIC card so as to ensure the normal running of the system.
Mul-Address Mode
The parameters of the two NIC cards can be congured independently. You can select LAN1
or LAN2 under Select NIC for parameter sengs. Select one NIC card as the default route.
When the system connects with the extranet, the data will be forwarded through the default
route.
3. Click IPv4 or IPv6 as you required.
4.
Oponal: Check Enable DHCP to obtain IP sengs automacally if a DHCP server is available on
the network.
5. Set related parameters.
Note
Valid MTU value range is from 500 to 1500.
6. Click Apply.
1.3
Congure HDD
Ensure the video recorder storage media is well. You can install at least one HDD and inialize it, or
create a RAID and inialize it.
Network Video Recorder User Manual
7

HIKVISION iDS-9600NXI-I16/4F Series Specifications

General

Brand	HIKVISION
Model	iDS-9600NXI-I16/4F Series
Category	Network Hardware
Language	English