Loading/saving settings
60
3.1
Loading settings
UM Basic Configuration L3P
Release
7.1
12/2011
Note: The loading process started by DHCP/BOOTP (see on page 41
“System configuration via BOOTP”) shows the selection of “from URL & save
locally” in the “Load” frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the “Load” frame.
3.1.3 Resetting the configuration to the state on
delivery
The device enables you to
reset the current configuration to the state on delivery. The locally saved
configuration is kept.
reset the device to the state on delivery. After the next restart, the IP
address is also in the state on delivery.
Setting in the system monitor
Select 5 “Erase main configuration file”
This menu item allows you to reset the device to its state on delivery. The
device saves configurations other than the original one in its Flash
memory in the configuration file *.cfg.
Press the Enter key to delete the configuration file.
Select the
Basics: Load/Save dialog.
Make your selection in the "Delete" frame.
Click "Delete configuration". The device will delete its configuration
immediately.
To Next Page
Loading...
Need help?
General
