About this Manual
UM Basic Configuration L3P
Release
7.1
12/2011
9
About this Manual
The “Basic Configuration” user manual contains the information you need to
start operating the device. It takes you step by step from the first startup
operation through to the basic settings for operation in your environment.
The following thematic sequence has proven itself in practice:
Set up device access for operation by entering the IP parameters
Check the status of the software and update it if necessary
Load/store any existing configuration
Configure the ports
Set up protection from unauthorized access
Optimize the data transmission with network load control
Synchronize system time in the network
Perform an operation diagnosis
Store the newly created configuration in the non-volatile memory.
The “Installation” user manual contains a device description, safety
instructions, a description of the display, and the other information that you
need to install the device.
The “Redundancy Configuration User Manual” document contains the
information you require to select the suitable redundancy procedure and
configure it.
The “Industry Protocols” user manual describes how the device is connected
by means of a communication protocol commonly used in the industry, such
as EtherNet/IP and PROFINET IO.
To Next Page
Loading...
Need help?
General
