36
HITRON CGNV2 USER’S GUIDE
CABLE
2.5 THE PASSWORD SCREEN
Use this screen to change the password with which you log in to the CGNV2.
NOTE: If you forget your password, you will need to reset the CGNV2 to its factory
defaults.
Click Cable > Password. The following screen displays.
FIGURE 9: The Cable > Password Screen
Modulation This displays the type of modulation that each
downstream channel uses. Possible modulation types
Signal Strength (dBuV)
This displays the transmitted power of the signal of each
upstream data channel to which the CGNV2 is
connected, in
dBuV.
Channel ID This displays the ID number of each channel on which
the upstream signal is transmitted.
Cable Modem IP Information
IP Address This displays the CGNV2’s WAN IP address. This IP
address is automatically assigned to the CGNV2
Subnet Mask This displays the CGNV2’s WAN subnet mask.
Gateway IP This displays the gateway IP address of the device on
the WAN to which the CGNV2 is connected.
DHCP Lease Time This displays the time that elapses before your device’s
IP address lease expires, and a new IP address is
assigned to it by the DHCP server.
TABLE 8: The Cable > Status Screen (continued)
To Next Page
Loading...
Need help?
General