82
HITRON CGNV2 USER’S GUIDE
WIRELESS
Run WPS Use these buttons to run Wifi Protected Setup (WPS):
Click the PBC button to begin the Push-Button
Configuration process. You must then press the PBC
button on your client wireless devices within two
minutes in order to register them on your wireless
network.
Click the PIN button to begin the PIN configuration
process. In the screen that displays, enter the WPS
PIN that you want to use for the CGNV2, or the WPS
PIN of the client device you want to add to the
network.
FIGURE 28: WPS PIN
WPS Current Status This displays whether the WPS function is active, idle or
not used.
SSID Setting This displays Primary SSID.
NOTE: You may have additional BSSIDs, depending on
your contract with your service provider.
SSID Name Enter the name that you want to use for your wireless
network. This is the name that identifies your network,
and to which wireless clients connect.
NOTE: It is suggested that you change the SSID from its
default, for security reasons.
Hidden Use this field to make your network visible or invisible to
other wireless devices.
Select the checkbox if you do not want the CGNV2 to
broadcast the network name (SSID) to all wireless
devices in the coverage area. Anyone who wants to
connect to the network must know the SSID.
Deselect the checkbox if you want your network
name (SSID) to be public. Anyone with a wireless
device in the coverage area can discover the SSID,
and attempt to connect to the network.
TABLE 26: The Wireless > Basic Screen (continued)
To Next Page
Loading...
Need help?
General