HP
Series
6000
Hardware
Installation
Manual
Connecting
the
Power
Cord
The various power cords available are shown in the Disk Product Specifications
and
Site Environmental Requirements Handbook,
part
number 5955-3456. Each
mass storage system is shipped with an appropriate power cord.
Warning
Note
•
The
ac
branch
service
must
be
properly
current-protected
by
either
a
fuse
or
a
circuit
breaker.
•
Use
only
a UL/CSA
approved
power
cord,
SVT
type,
rated
for
suitable
voltage
and
current.
These
power
cords
have
two
conductors
plus
a
ground.
Failure
to
use
the
proper
power
cord
could
result
in
a
shock
or
fire
hazard.
• Do
not
open
the
power
supply. The
power
supply
contains
no
customer-serviceable
parts.
Your
mass storage system has an automatic ranging power
supply. This means
that
a voltage selector switch
and
external
fuse are unnecessary. Automatic ranging power supplies have
internal fuses
that
only fail if the power supply malfunctions.
To
attach
the
power cord:
1. Set
the
[LiNE-) switch to the 0 (out) position.
2. Connect
the
female end of the power cord to
the
-AC
LINE connector
at
the
rear
of
the
mass storage system.
Mass Storage System 1·5
To Next Page
Loading...
Need help?
General