Chapter 3 41
Remove/Replace System Components
Removing/Replacing System Components
Replacing the Front Bezel and Top Cover
This section describes how to replace the HP B2600 workstation’s front bezel and top cover.
After you have completed the necessary component upgrades to your workstation, you
need to replace the top cover and bezel on you workstation.
Replacing the Front Bezel and Top Cover
1. Slide the top cover back on the workstation and secure it by screwing in the captive
screws.
2. Next, push the bezel in place on the front of the workstation. See Figure 3-2.
Figure 3-2. Front Bezel and Top Cover Replacement
Bezel Release Buttons
Captive Screws
To Next Page
Loading...
Need help?
General