HP C8088B Administrator's Guide

ENWW TCP/IP Configuration 102
Moving to Another Network
Note For HP Jetdirect wireless print servers, this section
assumes that a wireless connection to your network
has been established.
Moving an HP Jetdirect wireless print server to
another network will require a new wireless
connection to that network.
When moving an HP Jetdirect print server that is configured with
an IP address to a new network, make sure that the IP address does
not conflict with addresses on the new network. You may change
the IP address of the print server to one that can be used on the new
network, or erase the current IP address and configure another
address after you are installed on the new network. See Chapter 8
,
“Troubleshooting the HP Jetdirect Print Server
,” for instructions to
reset the print server to factory default settings.
If the current BOOTP server is not reachable, you may need to
locate a different BOOTP server and configure the printer to this
server.
If the print server was configured using BOOTP, DHCP or RARP,
edit the appropriate system files with updated settings. If the IP
address was manually set (for example, from the printer control
panel or Telnet), reconfigure IP parameters as described in this
chapter.

HP C8088B Specifications

General

Brand	HP
Model	C8088B
Category	Printer Accessories
Language	English