ENWW HP Jetdirect Configuration Page 220
TCP/IP Protocol Information
Information in this section of the Jetdirect configuration page is
described in Table 9.6
. For error messages, see Table 9.12.
Table 9.6 TCP/IP Configuration Information (1 of 4)
Message Description
STATUS: Current TCP status.
READY: Indicates the HP Jetdirect print server is awaiting
data over TCP/IP.
DISABLED: Indicates that TCP/IP was manually disabled.
INITIALIZING: Indicates that the print server is searching
for the BOOTP server, or trying to get the configuration file
through TFTP. An additional status message may also be
displayed.
An error code and message is displayed if the print server
is not ready. For more information, see Table 9.12
.
HOST NAME: The host name configured on the print server. It may be
truncated.
NOT SPECIFIED: Indicates that no host name was
specified in a BOOTP response or TFTP configuration file.
NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx
represents the last six digits of the LAN hardware (MAC)
address.
IP ADDRESS: The Internet Protocol (IP) address assigned to the
HP Jetdirect print server. This is a required entry for
operation of the print server on a TCP/IP network. During
initialization, a temporary value 0.0.0.0 is displayed. After
two minutes, a default IP address 169.254/16 or
192.0.0.192 is assigned.
NOT SPECIFIED: Indicates that an IP address is not
assigned or the value is zero.
SUBNET MASK: The IP subnet mask configured on the HP Jetdirect print
server. During initialization, a temporary value 0.0.0.0 is
displayed. Depending on configuration parameters, the
print server may automatically assign a usable default
value.
NOT SPECIFIED: Indicates that a subnet mask is not
configured.
To Next Page
Loading...
Need help?
General
