ENWW TCP/IP Configuration 54
Table 3.3 TFTP Configuration File Parameters (1 of 10)
General
passwd:
A password (up to 16 alphanumeric characters) that allows administrators to
control changes of HP Jetdirect print server configuration parameters through
Telnet, HP Web Jetadmin, or embedded Web server. The password may be
cleared by a cold reset.
sys-location:
Identifies the physical location of the printer (SNMP sysLocation object). Only
printable ASCII characters are allowed. The maximum length is 64 characters. The
default location is undefined. (Example: 1st floor, south wall)
sys-contact:
ASCII character string (up to 64 characters) that identifies the person who
administers or services the printer (SNMP sysContact object). This may include
how to contact this person. The default contact is undefined.
ssl-state:
Sets the print server’s security level for Web communications:
1 (default): Forced redirection to the HTTPS port. Only HTTPS (secure HTTP)
communications can be used.
2: Disable forced redirection to HTTPS. Both HTTP and HTTPS communications
can be used.
tftp-parameter-attribute:
Specifies whether TFTP parameters can be manually overwritten on the print
server (for example, through Telnet) after it has been configured by TFTP.
tftp-ro (default): Do not allow TFTP parameters to be manually changed, and
always overwrite manual configurations.
tftp-rw: Allow TFTP parameters to be manually changed, and always overwrite
manual configurations.
manual-ro: Do not allow TFTP parameters to overwrite manually configured
parameters.
TCP/IP Main
host-name:
Specifies the node name that will appear on the Jetdirect configuration page.
Default is NPIxxxxxx, where xxxxxx is the last six digits of the LAN hardware
address.
domain-name:
The domain name for the device (for example, support.hp.com). It does not
include the host name; it is not the Fully Qualified Domain Name (such as
printer1.support.hp.com).
dns-svr:
The IP address of the DNS (Domain Name System) server.
To Next Page
Loading...
Need help?
General
