ENWW Configuring for LPD Printing 165
LPD on Windows NT/2000 Systems
This section describes how to configure Windows NT/2000 networks
to use the HP Jetdirect LPD (Line Printer Daemon) services.
The process consists of two parts:
● Installing TCP/IP software (if not already installed).
● Configuring a network LPD printer.
Installing TCP/IP Software (Windows NT)
This procedure lets you check whether you have TCP/IP installed
on your Windows NT system, and to install the software if
necessary.
Note You may need your Windows System distribution
files or CD-ROMs to install TCP/IP components.
1. To check whether you have Microsoft TCP/IP Printing protocol
and TCP/IP printing support:
■ Windows 2000—Click Start, Settings, Control Panel. Then
double-click the Network and Dial-up Connections folder.
Double-click the Local Area Connection for your network
and click Properties.
If Internet Protocol (TCP/IP) is listed and enabled in the list
of components used by this connection, the necessary software
is already installed. (Proceed to “Configuring a Network
Printer for Windows 2000 Systems”). If not, go to step 2.
■ NT 4.0—Click Start, Settings, Control Panel. Then
double-click the Network option to display the Network
dialog box.
If TCP/IP Protocol is listed in the Protocols tab, and
Microsoft TCP/IP Printing is listed in the Services tab, you
have already installed the necessary software. (Proceed to
“Configuring a Network Printer for Windows NT 4.0
Systems.”) If not, go to step 2.
To Next Page
Loading...
Need help?
General
