HP ntegrity iLO 2 MP User Manual

Target: map1/telnetsvc1
The telnetsvc1 target represents the telnetsvc service provided by map1.
Table 6-39 shows telnetsvc1 target properties.
Table 6-39 telnetsvc1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled, Disabled
Shows whether telnet is enabled or disabled.EnabledState
Read-only
Set to telnet
The protocol this service provides.Protocol
Verbs
start Enables iLO 2 MP telnet service.
show Displays information.
stop Disables iLO 2 MP telnet service.
help Displays context-sensitive help.
Telnet Examples
The following examples show specific telnet commands.
Enable Telnet Service
</>-> start /map1/telnetsvc1
Disable Telnet Service
</>-> stop /map1/telnetsvc1
SSH
This section describes targets, their properties, and supported verbs necessary to enable or disable
SSH access to the iLO 2 MP.
Target: map1/sshsvc1
The sshsvc1 target represents the SSH service provided by map1.
Table 6-40 shows sshsvc1 target properties.
Table 6-40 sshsvc1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled, Disabled
Shows whether SSH service is enabled or
disabled.
EnabledState
Read-only
Set to SSH.
The protocol this service provides.Protocol
Verbs
start Enables iLO 2 MP SSH service.
stop Disables iLO 2 MP SSH service.
show Displays information.
help Displays context-sensitive help.
SMASH Server Management Command Line Protocol 137

HP ntegrity iLO 2 MP Specifications

General

Brand	HP
Model	ntegrity iLO 2 MP
Category	Server
Language	English