HP ntegrity iLO 2 MP User Manual

Figure 3-3 Connecting the SUV Cable to the Server Blade
Additional Setup
This section provides additional information to set up the iLO 2 MP.
Modifying User Accounts and Default Passwords
The iLO 2 MP comes preconfigured with default factory settings, including a default user account
and password. The two default user accounts on initial login are:
• All Rights (Administrator) level user:
login = Admin
password = Admin
• Console Rights (Operator) level user:
login = Oper
password = Oper
Login and password are case sensitive.
TIP: For security reasons, HP strongly recommends you modify the default settings during the
initial login session.
Make the following changes using any of the iLO 2 MP user interfaces.
To modify default account configuration settings, follow these steps:
1. Log in as the administrator to modify default user configuration settings
2. To modify default passwords, follow these steps:
a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify default passwords.
3. To set up user accounts, follow these steps:
a. Access the MP Main Menu.
b. Enter CM at the MP> prompt.
c. Enter UC at the MP:CM> prompt and follow the prompts to modify user accounts.
46 Setting Up and Connecting the Console

HP ntegrity iLO 2 MP Specifications

General

Brand	HP
Model	ntegrity iLO 2 MP
Category	Server
Language	English