HP ntegrity iLO 2 MP User Manual

Determine Gateway Address
</>hpiLO-> show -d properties=accessinfo
/map1/enetport1/lanendpt1/ipendpt1/gateway1
Set Gateway Address
</>hpiLO-> set /map1/enetport1/lanendpt1/ipendpt1/gateway1
AccessInfo=192.0.2.1
Determine Link State (Autosense)
</>hpiLO-> show -d properties=autosense /map1/enetport1
Set Link (Autosense)
</>hpiLO-> set /map1/enetport1 autosense=true
AccessInfo=192.0.2.1
Enable/Disable DHCP
</>hpiLO-> stop /map1/dhcpendpt1
</>hpiLO-> start /map1/dhcpendpt1
Determine all DNS settings
</>hpiLO-> show /map1/settings1/dnssettings1
Determine IP Address of the DNS Servers (primary, secondary, and tertiary)
</>hpiLO-> show -d properties=AccessInfo /map1/dnsserver*
or
</>hpiLO-> show -d properties=DNSServerAddresses
/map1/settings1/dnssettings1
Set Primary and Secondary DNS Server IPs
</map1/settings1/dnssettings1> set
DNSServerAddressess=192.0.2.1, 192.0.2.4
Set Tertiary DNS Server IP
</map1/settings1/dnssettings1> set DNSServerAddressess=,,192.0.2.6
vMedia
NOTE: vMedia command verbs are only available on server blade systems.
This section provides information on SM CLP vMedia targets, properties, and supported verbs.
It also lists examples of SM CLP vMedia use cases.
Target: map1/oemhp_vm1/cddr1
The cddr1 target represents the virtual CD-ROM device.
Table 6-49 cddr1 Properties
Access and ValuesDescriptionProperty Name
Read/write
The value is a URL with a maximum length
of 80 characters.
The image path and name for vMedia
access.
oemhp_image
Read/write
The following are valid values:
• Yes: Connect.
• No: Disconnect.
Used to connect or disconnect a vMedia
device and display the connection status.
oemhp_connect
Read-only
Set to .
• Yes
• No
Indicates if the Java applet is connected.oemhp_applet_connected
142 Using iLO 2 MP

HP ntegrity iLO 2 MP Specifications

General

Brand	HP
Model	ntegrity iLO 2 MP
Category	Server
Language	English