To Next Page

To Previous Page

3 Setting Up and Connecting the Console

To set up the console, follow these steps:

1. Determine the physical access method to connect cables. There are two physical connections

to the Integrity iLO 2 MP:

• Console serial port (RS-232)

• iLO 2 MP LAN port

2. Configure the Integrity iLO 2 MP and assign an IP address if necessary. Though there are

several methods to configuring the LAN, HP recommends DHCP with DNS. DHCP with

DNS comes preconfigured with default factory settings, including a default user account

and password. Other options include the following:

• ARP-Ping

• Console serial port (RS-232)

This chapter addresses the following topics:

• “Setup Checklist” (page 34)

• “Setup Flowchart” (page 35)

• “Preparing to Set Up iLO 2 MP” (page 36)

• “Configuring the iLO 2 MP LAN Using DHCP and DNS” (page 37)

• “Configuring the iLO 2 MP LAN Using ARP Ping” (page 37)

• “Configuring the iLO 2 MP LAN Using the Console Serial Port” (page 39)

• “Logging In to the iLO 2 MP” (page 40)

• “Physically Connecting the Server Blade to the iLO 2 MP” (page 40)

• “Additional Setup” (page 46)

HP ntegrity iLO 2 MP User Manual

Questions and Answers: