HP ntegrity iLO 2 MP User Manual

SSH Examples
The following examples show specific SSH commands.
Enable SSH Service
</>-> start /map1/sshsvc1
Disable SSH Service
</>-> stop /map1/sshsvc1
Network Configuration
Network commands enable you to display or modify network settings.
SM CLP Network Targets, Properties, and Verbs
This section describes targets, target properties, and supported verbs necessary to implement
the iLO 2 MP network configuration through SM CLP.
Target: map1/enetport1
The enetport1 target represents capabilities and management of the iLO 2 MP Ethernet port.
Table 6-41 shows enetport1 target information.
Table 6-41 enetport1 Properties
Access and ValuesDescriptionProperty Name
Read/write
Boolean values accepted.
Specified if the iLO 2 MP AutoSense feature
is enabled. If it is disabled, iLO 2 MP
network speed is set to 10 mb/s.
AutoSense
Read-only
The iLO 2 MP MAC address is formatted
as twelve hexadecimal digits
(10203040506) with each pair representing
one of the six octets of the MAC address.
Represents iLO 2 MP MAC address.PermanentAddress
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.
Target: map1/enetport1/lanendpt1
The lanendpt1 target represents the iLO 2 LAN endpoint settings.
Table 6-42 shows lanendpt1 target properties.
Table 6-42 lanedpt1 Properties
Access and ValuesDescriptionProperty Name
Read-only
The following are valid values:
Enabled, Disabled
Represents the iLO 2 MP LAN state.EnabledState
Read-only
The MAC address is formatted as twelve
hexadecimal digits (010203040506), with each
pair representing one of the six octets of the
MAC address.
Represents the iLO 2 MP MAC address.MACAddress
Verbs
138 Using iLO 2 MP

HP ntegrity iLO 2 MP Specifications

General

Brand	HP
Model	ntegrity iLO 2 MP
Category	Server
Language	English