1-34
Static Virtual LANs (VLANs)
Configuring VLANs
Customizing the Show VLANs Output
The show vlans custom command allows you to customize the information
displayed when executing the show vlans command.
Fields that can be included in the customized display are shown in the table
below.
The example in Figure 1-24 displays id at its default width, and will show up
to 20 characters of the VLAN name. The columns selected for display are
separated by spaces.
Syntax:
show vlans custom [port <port-list>] column-list
Select the information that you want to display in the order
you want to display it for the show vlans command. You can
display information for one port or range of ports. If <port-
list> isn’t specified, then all ports display.
Field Display Example Default
id VLAN Id 5 6
name VLAN Name Vlan55 32
status Status Port-based 10
voice Voice enabled No 5
jumbo Jumbos enabled No 5
ipconfig How the ip address was configured Manual
Disabled
DHCP/BootP
10
ipaddr (IPv4)
ipaddr (IPv6)
the IP address(es) 10.10.10.3
fe80::212:79ff:fe8d:8000
15 for IPv4
46 for IPv6
ipmask The subnet mask(s) 255.255.255.6
/64 (prefix for IPv6 is in format “/XX”)
15
proxyarp Whether proxy arp is configured No 5
localproxyarp Whether local proxy arp is configured No 9
state “Up” if at least one port is up Up 5
To Next Page
Loading...
Need help?
General