Figure 5-54 Installing a DIMM
Step 10 Install the air duct or the built-in drive assembly. For details, see 3.9 Installing the Air Duct
or 3.11 Installing the Built-in Drive Assembly.
Step 11 Install the chassis cover. For details, see 3.5 Installing the Chassis Cover.
Step 12 Install the server. For details, see 4.4 Installing the Server on Guide Rails.
Step 13 Connect the power cables. For details, see 5.4 PSU.
Step 14 Power on the server. For details, see 3.1 Powering On the Server.
Step 15 Use the Toolkit to perform a stress test on the new DIMM. For details, see the FusionServer
Tools 2.0 Toolkit User Guide.
Step 16 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the Huawei Rack Server iBMC User Guide.
----End
5.14 TPM/TCM
The server supports Trusted Platform Module (TPM) 2.0 and Trusted Cryptography Module
(TCM).
Note that:
l If the key function of the TPM/TCM is used to encrypt data, back up the data before
removing the TPM/TCM. If no backup is available, the encrypted data cannot be
decrypted after the TPM/TCM is replaced.
l Before removing the TPM/TCM, check whether some TPM/TCM functions have been
set on the BIOS. If yes, you need to set these functions again after replacing the TPM/
TCM. For details, see the Huawei Server Purley Platform BIOS Parameter
Reference.
2288H V5 Server
User Guide
5 Optional Part Installation
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 163
To Next Page
Loading...
Need help?
General