5.17 Left Mounting Ear
To install the left mounting ear, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Power off the server. For details, see 3.2 Powering Off the Server.
Step 3 Remove the power cables. For details, see 3.7 Removing Cables from a PSU.
Step 4 Remove the server. For details, see 3.3 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 3.4 Removing the Chassis Cover.
Step 6 Remove the air duct or the built-in drive assembly. For details, see 3.8 Removing the Air
Duct or 3.10 Removing the Built-in Drive Assembly.
Step 7 Take a spare left mounting ear out of its ESD bag.
Step 8 Route the mounting ear signal cable through the chassis in the arrow direction. See (1) in
Figure 5-61.
Figure 5-61 Installing the left mounting ear
Step 9 Connect the mounting ear signal cable to the left mounting ear connector on the mainboard.
See (2) in Figure 5-61.
Step 10 Install the left mounting ear in the arrow direction. See (3) in Figure 5-61.
Step 11 Tighten the screws. See (4) in Figure 5-61.
Step 12 Install the air duct or the built-in drive assembly. For details, see 3.9 Installing the Air Duct
or 3.11 Installing the Built-in Drive Assembly.
2288H V5 Server
User Guide
5 Optional Part Installation
Issue 04 (2018-09-04) Copyright © Huawei Technologies Co., Ltd. 171
To Next Page
Loading...
Need help?
General