5.1.3.4 Suspending a HyperMetro Pair
If you need to stop service for one site due to site failure or other reasons, select the
corresponding site of the HyperMetro pair. Pausing may cause the data inconsistency on both
sites.
Prerequisites
The Running Status of HyperMetro pair is Normal or Synchronizing (The connection of
devices is normal).
The HyperMetro pair is not added to the HyperMetro consistency group.
Procedure
Step 1 Log in to DeviceManager.
Step 2 Choose Data Protection > HyperMetro > HyperMetro Pair.
Step 3 Right-click a HyperMetro pair that you want to suspend, and choose Pause from the shortcut
menu.
Step 4 Select Preferred or Non-Preferred site and click OK.
The security alert dialog box is displayed.
Step 5 Confirm the operation of pausing the HyperMetro pair.
1. Carefully read the contents of the dialog box, and click OK.
The Execution Result dialog box is displayed indicating that the operation successded.
2. Click Close.
NOTE
After the HyperMetro pair is suspended, data synchronization between the two storage arrays is also
suspended.
----End
5.1.3.5 Deleting a HyperMetro Pair
If a HyperMetro is no longer needed, you can delete it.
Prerequisites
You can delete the HyperMetro pair only when its Pair Running Status is Paused, Force
Start or To be synchronized, and its secondary LUNs are not mapped.
Procedure
Step 1 Log in to DeviceManager.
Step 2 Choose
Data Protection > HyperMetro > HyperMetro Pair.
Step 3 Select a HyperMetro that you want to delete and click Delete.
OceanStor V3 Series
HyperMetro Feature Guide for File
5 Management
Issue 05 (2018-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
153
To Next Page
Loading...
Need help?
General