Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 8 FTP, TFTP and XModem
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-13
tftp ipv6 tftp-server [ -i interface-type interface-number ] get source-filename
[ destination-filename ]
The router is configured to download files through TFTP.
8.5.3 Uploading Files Through TFTP
Do as follows on the router that serves as the TFTP client:
Run the following commands according to different types of the server IP address.
z
When the server IP address is in IPv4 format, run:
tftp tftp-server put source-filename [ destination-filename ]
The router is configured to upload files through TFTP.
z
When the server IP address is in IPv6 format, run:
tftp ipv6 tftp-server [ -i interface-type interface-number ] put source-filename
[ destination-filename ]
The router is configured to upload files through TFTP.
8.6 Limiting the Access to the TFTP Server
8.6.1 Establishing the Configuration Task
Applicable Environment
You can limit the access of the router to the specified TFTP server through TFTP.
Pre-configuration Tasks
Before configuring TFTP, complete the following tasks:
z
Powering on the router
z
Connecting the TFTP client with the server
Data Preparation
To configure TFTP, you need the following data.
No. Data
1 IP address of the TFTP server
2 ACL number
To Next Page
Loading...
Need help?
General
