Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 4 Basic Configuration
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-7
z
All commands have default views and privileges and need not be configured again.
z
When you run the command-privilege level rearrange command, the system prompts that a super
password that corresponds to level 15 users should be set, if the password that corresponds to the
level 15 users is not set. If N is selected, you need to set a password. If Y is selected, the command
levels are advanced in batches. In the latter case, the user levels cannot be advanced when you log in
to the router through methods other than the Console port.
4.2.10 Displaying System Status Messages
Using the display commands to get the following status messages:
z
System configuration message
z
System working status message
z
System statistics message
z
Restart message on Active Main Board (AMB)
See the related sections for display commands about protocols and interfaces. The following
only shows the system display commands.
Run the following commands in all views.
Commands Displaying System Configuration
Run the following commands as required:
z
Run the display version command to display the system edition.
z
Run the display clock command to display the system time.
z
Run the display users [ all ] command to display the terminal user.
z
Run the display saved-configuration command to display the original configuration.
z
Run the display current-configuration command to display the current configuration.
Commands Displaying System Status
Run the following commands as required:
z
Run the display debugging [ interface interface-type interface-number ]
[ module-name ] command to display the debugging status.
z
Run the display this command to display the configuration of the current view.
Commands Displaying System Statistics
Run the following commands as required:
Run :
display diagnostic-information [ file-name ]
The zystem diagnosis information is displayed.
When the system fails or performs the routine maintenance, you need collect a lot of
information to locate the fault. But you cannot collect enough information, because there are
many display commands. You can use the display diagnostic-information command to
collect the running information of the current modules in the system.
To Next Page
Need help?
General
