4 Basic Configuration
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
4-2 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
4.1 Introduction
Before configuring the services, you need to configure the basic system environments to meet
the requirements of the practical environments, such as the system name and system time.
4.1.1 Extension of Command Levels
By default, the product supports command levels at 0 to 3, which correspond to visit,
monitoring, configuration, and management respectively. This limited number of command
levels cannot meet the requirements to implement fine management on authorization of users
at the device end. In the networking environment, the product cannot interwork with devices
that support command levels at 0 to 15.
By using the extension of command levels, you can advance in batches the command levels at
0 to 3 to levels at 0 to 15.
If the levels of commands are not modified separately, all the command levels are adjusted
after advanced in batches:
z
Commands at levels 0 and 1 remain unchanged.
z
Commands at level 2 are advanced to level 10.
z
Commands at level 3 are advanced to level 15.
z
No command exists at levels 2 to 9 and 11 to 14.
Command levels at 2 to 9 and 11 to 14 do not correspond to the visit, monitoring,
configuration, and management levels. You can adjust commands to levels at 2 to 9 and 11 to
14 to implement fine management on authorization of users.
The advancement of commands levels at 2 and 3 to levels at 10 and 15 respectively is performed in
batches at one time.
4.1.2 Extension of User Levels
The command levels are advanced to 0 and 15, and the user levels also should be advanced to
0 and 15 from the previous levels at 0 to 3.
4.2 Configuring Basic System Environment
4.2.1 Establishing the Configuration Task
Applicable Environment
Before configuring the services, you need to configure the basic system environments to meet
the requirements of the practical environments.
Pre-configuration Tasks
Before configuring basic system environment, power on the router.
To Next Page
Loading...
Need help?
General
