Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 12 Patch Management
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12-3
12.2 Checking the Running of Patch in the System
12.2.1 Establishing the Configuration Task
Applicable Environment
At the same time, the system allows the running of only one patch. You need to confirm no
patch is running in the current system before installing a patch. If a patch runs in the system,
delete the patch before installing the new patch.
Pre-configuration Tasks
Before checking the running of patch in the system, complete the following tasks:
z
Ensuring that the router is started normally after power-on
z
Ensuring that the router can be logged in to
Data Preparation
None.
Configuration Procedures
No. Procedure
1 Checking the Running of Patch on the
12.2.2 Checking the Running of Patch on the RPU
Do as follows on the router to be upgraded.
Step 1 Run:
display patch-information
The running patch on the master RPU is checked.
Step 2 Run:
display patch-information slave
The running patch on the slave RPU is checked.
----End
Before installing a patch on the RPU, you need to check the running of patch on the master
and slave RPU s. For example:
<Quidway> display patch-information
No patch in the memory for CpuId < 9 >.
The np patch information
np patch file name:
To Next Page
Loading...
Need help?
General
