11 System Software Upgrade
Quidway NetEngine20/20E
Configuration Guide - Basic Configurations
11-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 05 (2010-01-30)
11.3.3 Specifying the System Software for the Next Startup of the
Slave RPU
Do as follows on the router to be upgraded.
Run:
startup system-software file-name slave-board
The system software package is specified for the next startup of the slave RPU.
This command only applies to the NE20E.
11.3.4 Checking the Configuration
Run the following commands to check the previous configuration.
Action Command
Display the information of startup
system software.
display startup
Running the display startup command, you can learn that the system software in the next
startup of the router is the system software specified in the upgrading operation. The system
software is the same for the master and slave RPU s.
<Quidway> display startup
MainBoard:
Configed startup system software: flash:/b030.bin
Startup system software: flash:/b030.bin
Next startup system software: flash:/b030.bin
Startup saved-configuration file: flash:/vrpcfg.zip
Next startup saved-configuration file: flash:/vrpcfg.zip
To Next Page
Need help?
General
