Quidway NetEngine20/20E
Configuration Guide - Basic Configurations 11 System Software Upgrade
Issue 05 (2010-01-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11-5
11.3 Specifying the System Software for the Next Startup
of the Router
11.3.1 Establishing the Configuration Task
Applicable Environment
Specify the same system software to the master and slave RPUs. Otherwise, the system is
broken down.
After the files are uploaded, you need to specify the system to use the newly loaded system
software when the router is restarted next time. It is recommended to use the absolute paths to
specify system software of the same version to the master and slave RPUs.
After the system software is specified, the system uploads the software at the specified path
when the router is restarted next time.
Pre-configuration Tasks
None.
Data Preparation
Before specifying the system software for the next startup of the router, you need to prepare
the absolute path of the system software.
Configuration Procedures
No. Procedure
1 Specifying the System Software for the Next Startup of the Master RPU
2 Specifying the System Software for the Next Startup of the Slave RPU
3 Checking the Configuration
11.3.2 Specifying the System Software for the Next Startup of the
Master RPU
Do as follows on the router to be upgraded.
Run:
startup system-software file-name
The big packet file is specified for the next startup of the master RPU.
To Next Page
Loading...
Need help?
General
