Logical partitioning
Information about logical partitioning.
Changing partition profile properties
Information about changing partition profile properties by using the HMC.
Dual IOA Enablement Card (FC 5662)
Information about the specifications for the Dual IOA Enablement Card.
SAS RAID controllers for AIX
Information about usage and maintenance information for the SAS RAID Controller for the AIX.
SAS RAID controllers for IBM i
Information about usage and maintenance information for the SAS RAID Controller for the IBM i.
SAS RAID controllers for Linux
Information about the usage and maintenance information for the SAS RAID Controller for Linux.
PCIe 2-Line WAN with Modem (FC 2893 (EN13), 2894 (EN14); CCIN
576C)
Learn about the features of the PCIe 2-Line WAN with Modem.
This adapter is a 2-line per port WAN with Modem PCIe adapter. Port 0 is the modem port and supports
V.92 56K Async PPP, V.92 data modem, V.44 data compression, V.34 FAX modem and FAX functions, such
as ECM and 2D/1D conversion. Port 0 does not provide Sync modem capabilities (SDLC and Sync PPP).
Port 1 is the RVX port and provides Bisync functionality.
2893 is the non-CIM (Complex Impedance Matching) version offered in all countries and regions except
Australia and New Zealand.
2894 is the CIM (Complex Impedance Matching) version offered only in Australia and New Zealand.
The FRU part numbers for the adapter are:
v FC 2893 and 2894: 44V5323
Adapter type
Short, x4, PCIe
If you are installing a new feature, ensure that you have the software that is required to support the new
feature and that you determine whether there are any prerequisites for this feature and attaching devices.
To check for the prerequisites, see IBM Prerequisite website (www-912.ibm.com/e_dir/eServerPrereq.nsf).
For details about slot priorities and placement rules, see the PCI adapter placement topic collection for
your system.
Operating system or partition requirements
If you are installing a new feature, ensure that you have the software that is required to support the new
feature and that you determine whether there are any prerequisites for this feature and attaching devices.
To check for the prerequisites, see IBM Prerequisite website (www-912.ibm.com/e_dir/eServerPrereq.nsf).
The adapter is supported on the following versions of the operating systems:
v Linux
– Red Hat Enterprise Linux 5.6 for POWER, or later
– SUSE Linux Enterprise Server 11 Service Pack 1, or later
v IBM i
– IBM i 7.1, or later
188 Power Systems: Managing PCI adapters for the IBM Power 710 Express or the IBM Power 730 Express
To Next Page
Loading...
Need help?
General