Is this ok [y/N]: y
Downloading Packages:
rsxx-utils-4.0.2.2487-1.el6.ppc64.rpm | 330 kB 00:00
Running rpm_check_debug
Running Transaction Test
Transaction Test Succeeded
Running Transaction
Installing : rsxx-utils-4.0.2.2487-1.el6.ppc64 1/1
Verifying : rsxx-utils-4.0.2.2487-1.el6.ppc64 1/1
Installed:
rsxx-utils.ppc64 0:4.0.2.2487-1.el6
Complete!
Next, you can verify whether the rs_info utility has installed correctly. For instructions, see “Verifying
whether the rs_info utility is installed in a Linux system or Linux virtual machine” on page 200.
You can also run the rs_info command to view the details of the IBM Flash adapters that are available in
the system. For instructions, see “Running the rs_info utility in a Linux system or Linux virtual
machine” on page 205.
Running the rs_info utility in an AIX system or an AIX logical partition:
Learn to run the rs_info utility in an AIX system or an AIX logical partition and understand the output.
The rs_info utility can be run on the PCIe Flash Storage adapters that are available in an AIX system or
an AIX logical partition, but do not work on defined storage adapters.
To identify the available storage adapters and then run the rs_info utility, complete the following steps:
1. Run the following command to determine the available storage adapters:
lsdev -Cc disk | grep "Flash Adapter"
An output similar to the following screen is displayed, which shows the available disks:
# lsdev -Cc disk | grep "Flash Adapter"
hdisk1 Defined 07-00-01 IBM Flash Adapter Disk
hdisk2 Available 07-00-01 IBM Flash Adapter Disk
hdisk3 Defined 08-00-01 IBM Flash Adapter Disk
Where, hdisk2 is the only available IBM Flash Adapter.
2. To run the rs_info utility on the available storage adapter, run the following command:
/usr/lpp/diagnostics/bin/rs_info
An output similar to the following screen is displayed, which shows the available disks:
202 Power Systems: Managing PCI adapters for the IBM Power 710 Express or the IBM Power 730 Express
To Next Page
Loading...
Need help?
General