Note: A medium-sized retractable-ballpoint pen is preferred or an equivalent item with a small
opening can be used. The small opening must be large enough so the pen (or equivalent) will go
around the tip of the rivet, but small enough that it does not slide over the rivet and make contact
with the battery assembly bracket.
b. Slide the card off the edge of the work area just enough so rivet C can be pushed out of the back
of the adapter.
c. Hold the pen with the ballpoint retracted, place the pen on top of rivet C, and gently push straight
down until rivet C pushes out.
d. Repeat Steps 4b and 4c for the other rivet C.
e. Remove the cache battery pack A from the adapter.
f. Turn the adapter over and push the rivets C back into the adapter.
5. Install the new battery pack A onto the push rivets C of the adapter.
6. Reinsert the pins D into the rivets on the back of the card.
7. Connect the cache battery pack connector B to the adapter. The plug connects to the adapter in only
one way, so it cannot be inserted incorrectly.
8. Reinstall the adapter.
9. Verify that the part is correctly installed.
Replacing the cache battery pack on the 571F and 575B adapters
You might need to replace the cache battery pack. Use the procedure in this section to perform this task.
This procedure describes how to replace the cache battery pack on the PCI-X DDR double wide quad
channel Ultra 320 SCSI RAID adapter with auxiliary write cache, CCIN 571F (controller) and 575B
(cache). The following feature codes apply to this double-wide adapter.
Managing PCI adapters 211
To Next Page
Loading...
Need help?
General