90 Chapter 7: Working with adapter cards and drives
Installing a drive in bay 1
Bay 1 can hold a 3.5-inch slim drive, such as a diskette or tape drive.
1. Insert the drive into the bay. Align the screw holes
and insert the four screws.
(Front View)
Drive
2. Connect the power and signal cables to the drive.
Note:
If you add a diskette drive or a tape drive that attaches
to the Diskette connector, make sure the signal cable
you plug into the drive is attached to the Diskette
connector on the system board. To identify the Diskette
connector on the system board, see “Identifying signal
cable connectors” on page 86.
Drive
Signal Cable
Power Cable
(Back View)
To Next Page
Loading...
Need help?
General