12
2
MENU MODE
New2001
2
MENU MODE
■ Setting items
D MENU mode
See pages 18 to 22 for details of each MENU mode item’s
options and their default values.
Tone
Sets a channel tone type.
Frequency offset
Sets the frequency offset for duplex (repeater) operation.
Repeater tone
Sets a tone frequency used to access repeaters.
TSQL frequency
Sets a tone frequency for the Tone squelch function used in the FM
mode.
DTCS code
Sets a DTCS (both encoder/decoder) code for DTCS squelch func-
tion used in the FM mode.
DTCS polarity
Sets the DTCS polarity for the DTCS squelch function.
Tuning step
Sets the tuning step to change the frequency in the selected step
when rotating [DIAL]S.
Backlight
Sets the backlight brightness level.
Priority scan
Starts or stops the Priority scan.
Pause timer
Sets the scan pause time. When receiving signals, the scan pauses
according to the scan pause timer.
Resume timer
Sets the scan resume time from a pause after the received signal
disappears.
Weather alert
Sets to sound a beep when a weather alert signal is detected on a
preset weather channel. (Only for the USA version transceiver)
Operating mode
Sets the operating mode.
Home channel
Sets the often-used frequency as the Home channel in the VFO
mode or Memory mode.
EXMENU mode
Push [ï]D or [≈]D to enter the EXMENU mode.
D EXMENU mode
See the Icom website for details of the EXMENU mode items.
Mode and Tuning step items
Sets the operating mode and the tuning step.
Operating mode*
Sets the operating mode.
Tuning step*
Sets the tuning step to change the frequency in the selected step
when rotating [DIAL]S.
*You can set in the MENU mode.
To Next Page
Loading...
Need help?
General
