CHANGING BLOW-BY FILTER
Figure 26
The blow-by filter is positioned, by means of a support, to
the gearbox su pporting bracket in front of the passenger cab
water/heatin g water heat exchanger.
The blow-by filters can only be replaced by taking the unit
apart completely and disassembling the same at the bench.
- Disconnect the inlet pipe (3) to the filter and the
condensed oil drain pipe (2) to the sump.
- Loosen the straps that retain the sleeves (4) for vapour
escape towards the outlets.
- Unscrew the screws (5) securin g the filter on its bracket.
Improper waste disposal is a threat for the
environment. Potentially hazardous waste used on
IVECO vehicles includes lubricants, fuels, coolants,
filters and batteries.
— Use watertight containers when draining off
fluids. Never use containers for foodstuffs or
beverages that can lead people to drink from
them.
— Never throw waste on the ground, on tips or
in water c ou rses.
— Obtain information on the appropriate ways
of recyc lin g or disposing of waste from th e
local authorities or c ollect ion centres.
Support the blow-by filter to prevent sudden
disconnection.
- Loosenscrews(5)onbothsides,thenseparatethetwo
covers (4) from the filter (1) body.
- Take out the two filters (2), then replace them.
- Re-assemble the various parts after washing t he body an d
covers with a suitable detergent.
- After the filter has been fitted, place it into its own
housing on the support secured to the gearbox
supporting bracket.
Figure 27
Replace the gasket (3).NOTE
NOTE
SECTION 3 - INDUSTRIAL APPLICATION
95
VECTOR 8 ENGINES
Print P2D32V001E Base - April 2006
To Next Page
Loading...
Need help?
General
