To Next Page

To Previous Page

- that there are no water leaks from the c onnecting

sleeves of engine cooling circuit pipes and cab internal

heating pipes, tigh t en the clamping collars if required;

- the connection between the low pressure fuel pipes and

the relevant connectors;

- that there are no oil leaks between the cover and the

cylinder head, between oil sump and engine block,

between heat exchanger oil filter and the relevant

housings and between the different pipes in the

lubricating c ircuit;

- that there are no fuel leaks from the fuel pipes;

- that there are no air leaks from pneumatic pipes (if

fitted);

Carefully chec k and bleed the engine c ooling equipment by

repeated draining operations.

Checks and inspections

Start the engine and leave it running just above the

idling speed, wait until th e c oolan t reaches the

temperature necessary to open the thermostat and

then check:

The following checking inspections must be carried

out after th e engin e assembly on the vehicle .

NOTE

SECTION 3 - INDUSTRIAL APPLICATION

VECTOR 8 ENGINES

Print P2D32V001E Base - April 2006

Iveco VECTOR Series User Manual

Questions and Answers: