Iveco VECTOR Series User Manual

- Fit the low—pressure pump (2) together with the
coupling drive (4), O—ring and spacer (3) on the back of
the gearbox: tighten the screws (1) to the prescribed
torque.
Figure 79
Figure 80
Figure 81
- Fit the cooling pump.
- Ifthesamepumpisusedreplaceseal(3).
- If necessary, replace the pump gear (1) tightening the
bolt (2) to the recommended torque.
- During assembly, chec k that th e coupling drive and the
teeth on the front of the secondary circuit cooling pump
gear show no signs of wear or cracks. Change an y
damaged parts.
- Tighten the screws securing the low—pressure pump
support to the gearbox to the prescribed torque.
Having to tighten screw (2), it is necessary to
prevent the gear (1) from turning in an appropriate
manner without damaging the parts. Before
tightening, lubricate the screws with UTDM oil or
alternatively with engin e oil. (The gear has a
left-hand locking screw).
- At the front of the gearbox, fit the secondary system
cooling circuit pump together with the gears.
- Supporting the pump place it in its seat. Tighten the
M10x1.5 nuts securing the water pump to the front gear
cover 33 ÷ 40 Nm.
- Then fit the pipe (1) securing it to the actual pump and
the hose (2) using the two bolts (1).
Whilst fitting the drive coupling, check that the front
drive teeth on the pump gear are properly housed
inside the splining.
89792
103475
103229
For all applications
NOTE
For G-DRIVE / SPRINKLER and GRIFFON applications
NOTE
SECTION 3 - INDUSTRIAL APPLICATION
37
VECTOR 8 ENGINES
Print P2D32V001E Base - April 2006

Iveco VECTOR Series Specifications

General

Brand	Iveco
Model	VECTOR Series
Category	Engine
Language	English