16
3 Initial Setup
Turning the TV On for the First Time
Always disconnect the TV from the mains socket when not in use for a long period of time.
The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
Do not connect the TV to the mains
supply until you have completed all
the connections.
Initial Setup
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on
the back of your TV.
2. Insert the power cable into the power socket on the back of the TV, plug the TV into a mains socket and switch on at the
mains.
3. In standby mode, press the
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
SPDIF
Optic.OUT
VGA
ANT.
HDMI 2
(ARC)
LAN
AV IN
SPDIF
Optic.OUT
VGA
ANT.
HDMI 2
(ARC)
HDMI 3
LAN
AV IN
RF coaxial cable
(not included)
Router
(not included)
To Next Page
Loading...
Need help?
General
