Keithley 2182 User Manual

E-6 Example Programs
Storing readings in buffer
The reading buffer in the Model 2182 is flexible and capable. It has three controls, which are
found in the TRACe subsystem. There are commands to control:
• The size of the buffer (in readings).
TRACe:POINts <NRf>
• Where the data is coming from (before or after the CALCulate1 math post-processing).
TRACe:FEED SENSe1 store unprocessed readings
TRACe:FEED CALCulate1 store math processed readings
• Select buffer control mode.
TRACe:FEED:CONTrol NEVer immediately stop storing readings
TRACe:FEED:CONTrol NEXT start now, stop when buffer is full
The following example program sets up the Model 2182 to take 20 readings as fast as it can
into the buffer, and then reads the data back after the buffer has filled.
'Example program to demonstrate the reading buffer
'For QuickBASIC 4.5 and CEC PC488 interface card
'Edit the following line to where the QuickBASIC
'libraries are on your computer
'$INCLUDE: 'c:\qb45\ieeeqb.bi'
'Initialize the CEC interface as address 21
CALL initialize(21, 0)
'Reset controls and put trigger model in IDLE state
CALL SEND(7, "*rst", status%)
'Reset STATus subsystem (not affected by *RST)
CALL SEND(7, "stat:pres;*cls", status%)
CALL SEND(7, "stat:meas:enab 512", status%) 'enable BFL
CALL SEND(7, "*sre 1", status%) 'enable MSB
CALL SEND(7, "trig:coun 20", status%)
'TRACe subsystem is not affected by *RST
CALL SEND(7, "trac:poin 20", status%)
CALL SEND(7, "trac:feed sens1;feed:cont next", status%)
'Start everything
CALL SEND(7, "init", status%)
'Initialize reading$ while the 2182 is busy taking readings
reading$ = SPACE$(4000)
WaitSRQ:
IF (NOT(srq%)) THEN GOTO WaitSRQ
CALL SPOLL(7, poll%, status%)
IF (poll% AND 64)=0 THEN GOTO WaitSRQ
CALL SEND(7, "stat:meas?", status%)
CALL ENTER(S$, length%, 16, status%)
CALL SEND(7, "form:elem read,unit" status%)
CALL SEND(7, "trac:data?", status%)
CALL ENTER(reading$, length%, 16, status%)
PRINT reading$
NOTE: To repeat buffer storage, send the following command and then repeat the steps
following the “Start everything” comment in the previous example.
CALL SEND(7, "feed:cont next", status%)

Keithley 2182 Specifications

General

Brand	Keithley
Model	2182
Category	Measuring Instruments
Language	English