Keithley 2182 User Manual

14-2 SCPI Reference Tables
• Table 14-1 — CALCulate command summary
• Table 14-2 — CALibrate command summary
• Table 14-3 — DISPlay command summary
• Table 14-4— FORMat command summary
• Table 14-5 — OUTPut command summary
• Table 14-6 — ROUTe command summary
• Table 14-7 — SENSe command summary
• Table 14-8 — STATus command summary
• Table 14-9 — SYSTem command summary
• Table 14-10 — TRACe command summary
• Table 14-11 — Trigger command summary
• Table 14-12— UNIT command summary
General notes
• Brackets ([ ]) are used to denote optional character sets. These optional characters do not
have to be included in the program message. Do not use brackets in the program
message.
• Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets in
the program message.
• The Boolean parameter (<b>) is used to enable or disable an instrument operation. 1 or
ON enables the operation, and 0 or OFF disables the operation.
• Upper case characters indicate the short-form version for each command word.
• Default Parameter — Listed parameters are both the *RST and SYSTem:PRESet
defaults, unless noted otherwise. Parameter notes are located at the end of each table.
• Ref — Refers you to the section (Sec) that provides operation information for that
command or command subsystem.
• SCPI — A checkmark (√) indicates that the command and its parameters are SCPI
confirmed. An unmarked command indicates that it is a SCPI command, but does not
conform to the SCPI standard set of commands. It is not a recognized command by the
SCPI consortium. SCPI confirmed commands that use one or more non-SCPI
parameters are explained by notes.

Keithley 2182 Specifications

General

Brand	Keithley
Model	2182
Category	Measuring Instruments
Language	English