Keithley 2182 User Manual

P
Percent (%) 4-7
Performance commands 15-16
Performance considerations 2-5
Power-Up 1-14
Power-up sequence 1-15
Primary address selection 11-8
Program examples E-2
Pulse Delta I-3
Fixed output I-11
Measurement units I-11
Pumpout current (low charge injection
mode) 2-9
Q
QuickBASIC programming 11-8
R
Rack mount kits 1-5
Radio frequency interference C-6
Range 3-3
Range, Digits, Rate, and Filter 3-1
Rate 3-6
Ratio 5-2
Ratio and Delta 5-1
Ratio programming example 5-16
Reading hold (autosettle) 7-6
Rear panel summary 1-11
Recall 6-3
REL Key 4-3
Relative 4-3
Relative, mX+b, and Percent (%) 4-1
Remote Operation 11-1
ROUTe command summary 14-6
RS-232 connections 11-29
RS-232 interface reference 11-27
S
Safety symbols and terms 1-3
SCPI commands F-10
SCPI programming - ACAL, Front Autozero,
Autozero, LSYNC and Low Charge
Injection 2-10
SCPI programming - analog output 10-6
SCPI programming - buffer 6-5
SCPI programming - digits 3-5
SCPI programming - filter 3-12
SCPI programming - limits 8-5
SCPI programming - mX+b and percent 4-8
SCPI programming - range 3-4
SCPI programming - rate 3-7
SCPI programming - ratio and delta 5-16
SCPI programming - relative 4-4
SCPI programming - stepping and
scanning 9-12
SCPI programming - triggering 7-13
SCPI programming - voltage and temperature
measurements 2-20
SCPI Reference Tables 14-1
SCPI Signal Oriented Measurement
Commands 13-1
Selecting and configuring an interface 11-3
Selecting Delta 5-9
Sending and receiving data 11-27
SENSe command summary 14-7
Setting limit values 8-4
Setting line voltage and replacing fuse 1-15
Shielding C-8
Sorting resistors 8-7
Source resistance noise C-4
SourceMeter 5-10, 5-14, 9-14
Specifications A-1
Speed vs. noise characteristics 3-6
Standard cell comparisons 2-26
Status and Error Messages B-1
Status and error messages 1-16
STATus command summary 14-11
Status structure 11-13
STATus subsystem 15-7
Step/Scan configuration 9-7
Step/Scan overview 9-3
Stepping and Scanning 9-1
Stepping/Scanning controls 9-6
Stepping/Scanning examples 9-8
Store 6-2
Storing readings in buffer E-6
SYSTem command summary 14-12
T
Taking readings using the
READ? command E-7
Temperature configuration 2-18
Temperature configuration menu 2-18
Temperature only connections 2-15
Test systems I-5
Testing superconductor materials 5-19
Testing switch contacts 2-24
Thermal EMFs 2-22
Thermoelectric generation C-3
Thermoelectric potentials C-2
TRACe command summary 14-12
Trigger command summary 14-13
Trigger model 7-3

Keithley 2182 Specifications

General

Brand	Keithley
Model	2182
Category	Measuring Instruments
Language	English