Keithley 3721-ST User Manual

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-432 3700AS-901-01 Rev. D/June 2018
tsplink.writebit()
This function sets a TSP-Link trigger line high or low.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
tsplink.writebit(N, data)
N
The trigger line (1 to 3)
data
The value to write to the bit:
▪ Low: 0
▪ High: 1
Details
Use tsplink.writebit() and tsplink.writeport() to control the output state of the trigger
line when trigger operation is set to tsplink.TRIG_BYPASS.
If the output line is write-protected by the tsplink.writeprotect attribute, this command is
ignored.
The reset function does not affect the present states of the TSP-Link trigger lines.
Example
tsplink.writebit(3, 0)
Sets trigger line 3 low (0).
Also see
tsplink.readbit() (on page 11-422)
tsplink.readport() (on page 11-422)
tsplink.writeport() (on page 11-432)
tsplink.writeprotect (on page 11-433)
tsplink.writeport()
This function writes to all TSP-Link synchronization lines.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
tsplink.writeport(data)
data
Value to write to the port (0 to 7)

Keithley 3721-ST Specifications

General

Brand	Keithley
Model	3721-ST
Category	Multimeter
Language	English