3
7
7
What to do in an emergency Road warning
What to do in an emergency
Road warning
When in an emergency situation occurs
whilst driving or when you park by the
edge of the roadway, you must alert
approaching or passing vehicles to be
careful as they pass. For this, you should
use the hazard warning flasher.
Hazard warning flasher
The hazard warning flasher serves as a
warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
It should be used whenever emergency
repairs are being made or when the
vehicle is stopped near the edge of a
roadway.
Depress the flasher switch with the
ENGINE START/STOP button in any
position. The flasher switch is located in
the centre fascia panel. All turn signal
lights will flash simultaneously.
僅 The hazard warning flasher operates
whether your vehicle is running or not.
僅 The turn signals do not work when the
hazard flasher is on.
僅 Care must be taken when using the
hazard warning flasher whilst the
vehicle is being towed.
In case of an emergency whilst
driving
If an emergency situation occurs whilst
driving, stay calm and take the following
steps.
If the vehicle stalls whilst driving
1. Reduce your speed gradually, keep
-
ing a straight line.
2. Move cautiously off the road to a safe
place.
3. Turn on your hazard warning flasher.
4. Try to start the vehicle again. If your
vehicle will not start, contact a profes
-
sional workshop or seek other quali
-
fied assistance. Kia recommends to
contact an authorised Kia dealer/ser
-
vice partner.
If the engine stalls at a crossroad
or crossing
僅 If the engine stalls at a crossroad or
crossing, set the gear in the N (Neu
-
tral) position and then push the vehi
-
cle to a safe place.
To Next Page
Loading...
Need help?
General
