12-18 CK20
196OC30A196OC29A
(1) Engine Oil Filter
REPLACING HYDRAULIC OIL &
TRANSMISSION OIL FILTER (CK20H)
(1) Drain Plugs
EVERY 200 HOURS
REPLACING ENGINE OIL FILTER
1. Remove the oil filter.
2. Put a film of clean engine oil on the
rubber seal of the new filter.
3. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter by hand an additional half
turn only.
4. After the new filter has been replaced,
the engine oil normally decreases a
little. Make sure that the engine oil does
not leak through the seal and be sure
to check the oil level on the dipstick.
Then, replenish the engine oil up to
the prescribed level.
IMPORTANT
To prevent serious damage to the
engine, use only a KIOTI genuine
filter.
CAUTION
To avoid personal injury:
Be sure to sop the engine before
changing oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
CAUTION
To avoid personal injury:
Be sure to stop the engine before
changing the oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
1. Remove the drain plug at the bottom of
the transmission case and drain the
oil completely into the oil pan.
2. After draining reinstall the drain plug.
To Next Page
Loading...
Need help?
General
