12-20 CK20
196OC35A
Check to ensure the radiator hoses are
free from damage and are tightened prop-
erly every 200 hours or every 6 months,
whichever comes first.
1. If the hose clamps are loose or water
leaks from hose, tighten clamps
securely.
2. If the radiator hoses are swollen,
hardened, cracked, or otherwise
damaged, you must replace the hose.
It is a good practice to replace the radia-
tor hoses once every two years.
PRECAUTION AT OVERHEATING
Take the following actions in the event
the coolant temperature be nearly or
more than the boiling point, what is called
“Overheating”
1. Stop the machine operation in a safe
place and keep the engine unloaded
idling.
2. Don’t stop the engine suddenly, but
stop it after about 5 minutes of un-
loaded idling.
3. Keep yourself well away from the
machine for further 10 minutes or while
the steam blown out.
4. Checking that there is no danger of
burn, get rid of the causes of over-
heating according to the manual, see
“Troubleshooting” section, and then,
start the engine again.
CHECKING RADIATOR HOSE AND
CLAMP
(1) Radiator Hoses
(2) Clamp
196OC36A
(1) HST Oil Line
(2) Power Steering Line
CK20H
CHECKING HST OIL LINE (CK20H)
& POWER STEERING LINE
1. Check to see that all hydraulic lines
and hose clamps are tight and
undamaged.
2. If damage is found you should replace
the hose or clamp at once.
To Next Page
Loading...
Need help?
General
