6-2 CK20
196O601A
1. To set the parking brake;
1) interlock the brake pedals
2) Depress the brake pedals
3) Latch the brake pedals with the
parking brake lever.
2. To release the parking brake you
should press the brake pedals again.
STARTING THE ENGINE
(1) Parking Brake Lever
(A) Interlock the Brake Pedals
(B) “DEPRESS”
(C) “PULL”
MAKE SURE THE PARKING BRAKE
IS SET
CAUTION
To avoid personal injury:
You must read and understand
the warning and caution labels on
your tractor.
Proper ventilation is required
when operation your tractor in-
side a building or enclosed area.
Remember that exhaust fumes
can be deadly.
Never start your tractors engine
while standing on the ground.
This can prevent unexpected ac-
cident from happening.
IMPORTANT
Using starting fluid or ether to start
your tractor will cause damage and
void your tractors warranty.
A good way to start your tractors
engine after a long storage period
you should pull the stop knob and
turn the key over. This will allow time
for oil to reach every part of the trac-
tors engine before starting.
To avoid damage to the starter and
battery you should never continu-
ously start your tractor for more
than 30 second at a time.
IMPORTANT
Make sure that the parking brake
pedals are fully depressed be-
fore pulling the parking brake le-
ver up.
To Next Page
Loading...
Need help?
General
