PERIODIC SERVICE 12-25
196OC45A
(1) Radiator Cap (A) FULL
(2) Recovery Tank (B) LOW
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator
drain plug and remove radiator cap.
The radiator cap must be removed to
completely drain the coolant.
3. After all coolant is drained, close the
drain plug.
4. Fill with clean water and cooling sys-
tem cleaner.
5. Follow directions of the cleaner
instruction.
6. After flushing, fill with clean water and
anti-freeze until the coolant level is just
below the port.
Install the radiator cap securely.
7. Fill with coolant up to the “FULL” mark
on the recovery tank.
8. Start and operate the engine for few
minutes.
9. Stop the engine and let cool.
10. Check coolant level of recovery tank
and add coolant if necessary.
Coolant
capacity
5.7
(1.50 U.S.gal.)
CAUTION
To avoid personal injury:
Do not remove the radiator cap
when the engine is hot. Then
loosen cap slightly to the stop the
relieve any excess pressure be-
fore removing cap completely.
CK20H
CK20
196OC51A
EVERY 2 YEARS
FLUSH COOLING SYSTEM AND
CHANGING COOLANT
(1) Drain Plug
IMPORTANT
Do not start engine without
coolant.
Use clean, fresh water and anti-
freeze to fill the radiator and re-
covery tank.
When the anti-freeze is mixed
with water, the anti-freeze mix-
ing ratio must be less than 50%.
Securely tighten radiator cap. If
the cap is loose or improperly
fitted, water may leak out and the
engine could overheat.
To Next Page
Loading...
Need help?
General
