9-2 CK20
196O901A
(1) Hydraulic Control Lever
(A) DOWN (N) NEUTRAL
(B) UP
Operating the hydraulic control lever ac-
tuates the hydraulic lift arm. This con-
trols the elevation of the 3-point hitch
mounted implement.
If the 3-point hitch can not be
raised by setting the hydraulic
control lever to the “UP” position
after long term storage or when
changing the transmission oil, fol-
low these air bleeding procedures.
1. Stop the engine.
2. Set the hydraulic control lever
to the “DOWN” position and
start the engine.
3. Operate the engine at low idle
speed for at least 30 seconds
to bleed air from the system.
Do not operate until the engine is
warmed up. If operation is at-
tempted when the engine is still
cold, the hydraulic system may
be damaged.
If noises are heard when imple-
ment is lifting after the hydraulic
control lever has been activated,
the hydraulic mechanism is not
adjusted properly.
Unless corrected the unit will be
damaged.
Contact your KIOTI dealer for
adjustment.
IMPORTANT
3-POINT HITCH CONTROL SYSTEM
HYDRAULIC CONTROL
To Next Page
Loading...
Need help?
General
