Kohler KD62V12 Operation And Maintenance Manual

Appendix
Standard tightening torques
Size Tightening torque Size Tightening torque
1)
VSTI ED VSTI o-ring
1)
VSTI ED VSTI o-ring
M60x2 - 400 Nm
295 ft-lb
- - -
Tab. 65: VSTI screw plug tightening torques for aluminium parts
1)
Do not use hydropneumatic screwdriver.
8.4.11
Assembling pipes with DKO connectors (EL, ET, EW, GZ, GZR, RED)
Fig. 137: DKO connector
Fig. 138: DKO connector lubrication
Information
Tolerances of the indicated tightening torques: 10%.
Always lubricate the thread before tightening these parts (engine oil).
Information
To assemble pipes with DKO connectors:
u When tightening the nut, make sure that the connector does not rotate.
u Tighten the nut by hand.
u Hold a wrench as close as possible to the nut.
u Tighten the nut with the wrench until the resisting point.
u Tighten the nut a further 90°.
Alternatively, refer to the following table for tightening sequence of the nut:
Size
Equivalent specification Size Equivalent specification
06L 20 Nm
15 ft-lb
06S 25 Nm
18 ft-lb
08L 30 Nm
22 ft-lb
08S 40 Nm
30 ft-lb
KD62V12 33521030301_8_1 EN_US 2022-09
© 2022 by Kohler Co. All rights reserved.
201

Kohler KD62V12 Specifications

General

Brand	Kohler
Model	KD62V12
Category	Engine
Language	English